GrabCAD 模型信息
10-Bay Hard Disk Drive Cage for Phanteks Enthoo Primo Case · 模型 181332
This rack installs into the bottom section of a Phanteks Enthoo Primo case. It holds 10 drives in removable bays, and you can screw a bonus 11th drive onto the right side. Enough space remains to install two 140mm fans below it (or three 120mm ones). It's the only rack I've seen where drives can be inserted sideways, instead of from the front. Everything is mounted with #6-32 screws, and a list of recommended hardware is included. Small pilot holes exist on the part where holes need to be drilled into the case, to make sure your bit gets positioned perfectly. Each drive is mounted with vibration-absorbing washers. You can print them in a flexible material, or find something similar off-the-shelf. In a pinch, it would probably work alright without the washers. It takes a bit of gentle angling left and right when inserting a drive to get the rear holes to line up, but isn't too difficult if you practice with one drive first on a mostly-empty bay.
- 格式
- STL、Rendering、SOLIDWORKS、Other
- 分类
- Computer、Fixtures
- 标签
- 未标注
- 数据更新
- 2026-10-20T14:47:39Z
