GrabCAD 模型信息
100-Cards Deck Case (Magic the Gathering Commander) · 模型 257035
This is a case for holding a 100 (single-sleeved) cards Magic the Gathering Commander Deck with a drawer for dices/tokens. I recently bought myself a Commander Deck and I did not want to buy a usual soft plastic case for it, so I decided to 3D print one myself. The functioning is very simple (see videos). There is a lid on top which rotates about one side. Then, there are 2 doors on the front and rear with gears that pull a rack attached to the deck plate under the cards. When the deck is fully up, the lid is hooked to the side of the main body to ensure the deck will not go back inside. The drawer serves the purpose of storing dices or tokens. I used PLA for 3D printing as it is commonly available. It took approximately 18 hours to print everything (0.17 mm layer height, no supports). The hinges are made with simple copper wire. I believe that the tolerances are fine. The total dimensions fit in the required 120.65 mm cube. This design was inspired from here: https://www.thingiverse.com/thing:674460 McGill University, Montreal, QC, Canada
- 格式
- Other、STEP / IGES、Rendering、STL
- 分类
- 3D printing、Hobby、Miscellaneous
- 标签
- extremeredesignengineeringpost2017、mtg、commander、printing、3d、gears、case、deck、edh、gathering、magic
- 数据更新
- 2026-09-16T13:27:48Z