17g Servo (JX/PDI 1171MG) Adapter for MN333 模型预览

GrabCAD 模型信息

17g Servo (JX/PDI 1171MG) Adapter for MN333 · 模型 390800

作者:Dan Fu

3D Printed Servo adapter for MN333 Replacement servo - PDI/JX 1171MG Remove original servo Cut original servo mounting stubs @ pumpkin level + 1,5mm height (this will be flush with the existing rib network) Drill out all holes on adapter to 1,5mm Place as shown in the assembly FrontAxle v2 Drill through diff ribs with 1,5mm drill bit IMPORTANT - use rubber bush kit to mount JX1171MG to adapter Gently heat tie rod within ~10mm range of horn Hold tie rod ends steady and keep hubs parallel while stretching out and bending tie rod, (Heat gently multiple times if needed), This should give you some clearance between tie rod and horn + linkage Fix linkage to horn (use the last or second-to-last hole) for good steer angle Enjoy your much-needed steering upgrade! Note: Taking off wheels is recommended for this

格式
STEP / IGES、Fusion 360
分类
3D printing、Tech、Toys
标签
mn333、servo、17g、1171 mg、upgrade
数据更新
2026-11-14T15:31:59Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。