GrabCAD 模型信息
25.7mm flare · 模型 191291
For ye flare I introduce to you the 26.5mm/4 bore(for your flare or looncher or some DIY bs) Warning: everything you do involving this project is your responsibility. In this file there is an assortment of different projectiles and two cases. #1: big 100gr for gnome capacity case proj 26.5 : make sure you do your own research on the amount of bp or nitro to use . #2: small 100gr capacity case proj 26.5 : this case is designed to be used for a 26.7flare gat for safety you can use loads of 50-75 gr of bp not recommended but i use some 60gr of bp + 5gr of fast smokeless gogo juice . #3: canister shell big proj. 26.5 : this canister can hold 9x 44. cal lead balls=2.9oz(this shot is on the heavy side you might not get good velocity) or use 2.6oz worth of 3⁄8 steel ball bearing(this can go through ¼” plywood with 75gr bp) there is space for creativity and make sure you use candle wax on the top to keep it from falling out and don't use hot glue it's too strong. Print it in 100% infill, supports are not necessary but it will only improve the looks of the hole on the bottom and do not worry about the TPU seal grooves; they will do fine without supports btw: (the softer the TPU seals are the better). #4: canister shell small proj. 26 .5 : this canister can hold 6x 44. cal lead balls=2.0oz(this shot is on the lighter side you might get good velocity and you can use more or faster powder on lighter loads) or use 21 31.cal lead balls = 2.3oz or 12 ⅜ ball bearings=1.6oz there is space for creativity and make sure you use candle wax on the top to keep it from falling out and don't use hot glue it's too strong. Print it in 100% infill, supports are not very necessary but it will only improve the looks of the part and do not worry about the TPU seal grooves; they will do fine without supports btw: (the softer the TPU seals are the better). #5: sand mold for crown proj. 25.5 :test under your caution i have not yet tested this or made it yet but its practically no longer a hollow point its a crown i intended this to be molded out of led so i tried to reduce its volume so it doesn't become to heavy .it can be molded out of brass or aluminum to make it lighter to achieve effective velocity but if you are using nitro lead is effective . when you print this mold make minimum density: 1 layer walls 5-10-20% infill for molten metal to have no serious obstruction or use some very low density pla the gnome: you know if you know ;) ........
- 格式
- STL
- 分类
- 3D printing、Military、Miscellaneous
- 标签
- reloading、case、flare
- 数据更新
- 2026-09-10T12:07:15Z
