GrabCAD 模型信息
3D-Origin-System · 模型 379975
A visual model, which shows the view orientations and axes directions for 3D-models. The dimensions: datum planes: squares of 50 mm length, measured over the arrow tips: approx. 85.25 mm A notice for PTC-users: the 3D-model has "saved views" with following definition: frt = front = vorne bac = back = hinten top = top = oben bot = bottom = unten sdr = side from right = rechts sdl = side from left = links A recommended syntax for the datum planes, which overstretches each of the 6 views: [x-y] = front -[x-y] = back [x-z] = top -[x-z] = bottom [y-z] = side from right -[y-z] = side from left For rotating about the axes the "right hand rule" is a big help. The thumb points in direction of the arrow tip of the axis, and your fingertips point in the mathematically positive rotating direction (counterclockwise direction). Personally I prefer the "frt"-orientation of the 3D-model as the same orientation with the perpendicular view on the drawing sheet, which is hanging on a wall. Uploaded 3D-data: STEP PTC Creo Parametric 2.0 I hope, that this model can show in an understanding way the view orientations and axes definitions for 3D-models. Espacially for newcomers, they want get starting of 3D-modeling, could it be a little help. Thank you for the attention of a little excursion, for defining a possible origin model, before starting in the world of 3D-modeling. Animation(s) and/ or suggestions for improvement of this model are always very welcome here. P.S.: The uploaded (.xls)-file can be used for printing out in 2D, cut out with scissors and fold it to a glued paper model (may be a puzzle work and/ or a challenge). Designations in the (.xls)-file: V = Vorne = Front H = Hinten = Back O = Oben = Top U = Unten = Bottom R = Rechts = Right L = Links = Left The directions of the three axes are also shown on each datum plane.
- 格式
- STEP / IGES、Rendering、Other
- 分类
- Just for fun
- 标签
- 未标注
- 数据更新
- 2026-10-07T17:54:25Z