GrabCAD 模型信息
5-Inch Drone Frame with Removable Landing Legs · 模型 219189
About the frame A custom 5-inch drone frame designed in Fusion 360 for my DIY drone project. The frame has been printed and assembled, and the motor electronics have been tested. It has not yet been flight-tested. It features a one-piece main frame, removable legs, battery strap slots and separate battery stoppers. The complete assembled drone shown in the photos weighs 472.5 g, including the battery and electronics. Included files Main frame — STL Leg — STL Battery stopper — STL Frame assembly — STEP, for modification This download contains the frame design and printed accessories only. Electronics, wiring and firmware are not included. Electronics and hardware used in my build SpeedyBee F405 V4 flight controller and ESC stack 4 × iFlight XING-E Pro 2207 2450KV motors Gemfan 51433 three-blade propellers WeAct Studio BluePill Plus development board — STM32F103C8T6 nRF24L01 radio module 4S LiPo battery — 14.8 V, 1500 mAh Battery straps, wiring and connectors Component dimensions and mounting holes can vary. Check your components against the STEP model before printing. Assembly - Legs: attached with M3 × 10 mm screws. - Battery stoppers: attached with M3 × 10 mm screws. - Flight controller and ESC: mounted using the hardware supplied with the SpeedyBee stack. - Motors: attached using the screws supplied with the motors. - STM32 board: secured with hot glue in its designated mounting area. - nRF24L01 module: secured with hot glue in its designated mounting area. - Battery: secured using straps through the frame slots. Printing Print one main frame, four legs and two battery stoppers. Suggested starting settings with a 0.4 mm nozzle: - Layer height: 0.2 mm - Walls: 5 - Infill: 40% - Top/bottom layers: 6 - Supports: as needed for the chosen orientation Print the main frame flat on the build plate. Preview all parts in the slicer and check support placement before printing. These are suggested starting settings, not the recorded settings of the original print. They have not been validated through flight testing.
- 格式
- STEP / IGES、STL、Rendering
- 分类
- 3D printing、Aviation、Robotics
- 标签
- fusion 360、3d printing、5inch、diy、rc、frame、quadcopter、drone
- 数据更新
- 2026-10-30T10:47:06Z
