GrabCAD 模型信息
Accumulator sense, pump unload assembly with flow control valve - XQEJLANBL · 模型 127570
This valve assembly is meant to charge an accumulator using a fixed displacement pump. It incorporates a ventable priority flow control valve. When the pressure reaches the set point of the valve, the priority flow control is vented and all of the pump flow is available to the system. When the pressure drops to the value determined by the fixed percentage of the pilot valve, the priority flow is used to recharge the accumulator. Only the priority flow is directed to the accumulator leaving the rest of the pump flow available to the system. The assembly has two additional features; a simple circuit that softens the unloading of the pump and a system over-pressure relief. When applying this assembly, a separate drain line is required to prevent erratic operation caused by tank line pressure fluctuations. NOTE: Careful consideration should be given when selecting an adjustment range. System pressure drops and flows tend to affect the operation of unloading valves. Low operating pressures combined with low differentials result in a very narrow band between unload and reset, requiring precise system design. High flow rates typically mean high pressure drops, which subtract from the differential the valve has to work with. The pressure setting and the resultant reseat pressure are in reference to the port 2 area of the QCD* pilot valve. Pump pressure will be higher and accumulator pressure will be lower due to pressure drop caused by flow. The porting on this assembly is large in relation to its capacity. This is done to encourage the use of correspondingly large piping to minimize problems caused by flow induced pressure drop. The spool design of the pilot valve allows it to maintain a fixed differential ratio because the areas are created by diameters on the spool that will not wear or change with use. The accumulator pilot valve must be set below any reliefs in the pump side of the system or severe heating could occur. The relief in this package is meant to be an over-pressure device. It is set higher than the highest setting of the pilot valve and capped.
- 格式
- Rendering、Other、STEP / IGES、PTC Creo Elements
- 分类
- Components、Industrial design、Machine design
- 标签
- hydraul、fluidpower、industrialhydraulics、industrialautomation、hydraulicsolutions、pressurecontrol、systemreliability、hydraulicengineering、powerunits、hydraulictech、xqcglanbk、pumpunload、accumulatorsense、hydraulicsystems、hydraulicassembly
- 数据更新
- 2026-10-07T05:59:23Z
