GrabCAD 模型信息
Advanced Independent Metering without Load Sense - XCDXLJNXL · 模型 127620
This valve assembly provides overrunning load-control and load-port relief protection. The eSense® technology is a self-contained closed loop motion control package that is optimized to save energy waste and reduce un-commanded bounce. Counterbalance valves should be set at least 1.3 times the maximum load induced pressure. eSense® has not yet been validated for applications where the load goes over center. Contact Sun for more information. The eSense® algorithm can be fine tuned for varying application requirements. eSense® is J1939 CAN Enabled. Provides cool and filtered oil to the actuator on every cycle. The counterbalance valves in this assembly do not have positive seals on the pilot section and will pass between 2 and 20 in³/min./1000 psi (0,03 and 0,3 L/min./70 bar) between port 2 and port 3, depending on load pressure. Load holding algorithm driven by Enovation Controls MC2-18-6. Refer to QuickStart guide for initial setup: eSense® Quick Start Portal This package is also available at a lower flow rate, model code: XCCX Backpressure at port 2 adds to the effective relief setting at a ratio of 1 plus the pilot ratio times the backpressure. Command can be either analog signal or CAN bus message.
- 格式
- PTC Creo Elements、Rendering、Other、STEP / IGES
- 分类
- Components、Industrial design、Machine design
- 标签
- motioncontrol、hydraulicengineering、industrialautomation、electrohydraulic、fluidpower、precisionhydraulics、energyefficienthydraulics、hydraulicsystem、independentmetering、hydrauliccontrols、xcdxljnxl、noloadsense、advancedindependentmetering
- 数据更新
- 2026-10-07T06:32:09Z
