GrabCAD 模型信息
Aventon Ramblas eMTB Trailer Adapter · 模型 418672
This bike trailer adapter is for the Aventon Ramblas eMTB, and is installed where the kickstand for the bike is normally installed. I know it fits the large and small frame Aventon Ramblas, so you can assume it fits the medium frame as well. There are two models: (a) A bare-bones, thin-walled model that uses much less filament that I recommend you print to verify this model fits your Aventon Ramblas (before printing the full model). For this part, I recommend 2 walls and thin top and bottoms with just enough infill to support the top (minimize print time and wasted filament). (b) The full model that has the adapter for my trailer that you see in the photograph. For this part, I recommend printing this as solid as possible (as strong as possible). If your bike trailer has a different connecting mechanism than my bike trailer (very likely), you will need to model your own connector. My connector assumes a 19mm diameter solid rubber cylinder with a 6mm hole near the end; in the photo, you can see the 6mm x 55mm Shaft Locking Pin I use to connect and disconnect the trailer. It may not be necessary, but a nylon zip tie is being used (see photograph) to keep the back locked in place (in case of flexing, we want to keep it away from the rotating parts). I will likely use two or more zip ties to ensure it stays in place. Two M6 x 30mm button head bolts are used with two square M6 nuts where the kickstand bolts reside. It may not be necessary, but a nylon zip tie is being used (see photograph) to keep the back locked in place (in case of flexing, we want to keep it away from the rotating parts). I will likely use two or more zip ties to ensure it stays in place. The original plan was to place the zip tie on the frame one inch forward than where you see it in the picture. Channels were cut in the model to hold it in place, and all but the one channel (the one on the top middle) are being used. If I ever re-print this, I will change the model to have a channel on the top where you see the zip tie cross the top. I will also add a channel for a zip tie that goes around the top back (If you re-mix this, please share your improvements). I recommend printing this using a tough flexible filament like TPU or Nylon (no carbon-fiber or glass-fiber, some flex is required when pushing it into place). I printed these with the bottom (the long narrow flat side) down and no supports.
- 格式
- Rendering、STL
- 分类
- 3D printing
- 标签
- aventon、ramblas、bike、bicycle、trailer、adapter
- 数据更新
- 2026-11-12T12:43:30Z