GrabCAD 模型信息
Balsa Wood Bridge · 模型 370951
I understand the concept of people doing their own research, but most of the balsa wood competition websites are just a bunch of arrogant snobs.They wouldn't even give one guy any hints were to start his research when all he wanted to know was the basics so he and his teenage daughter could have some quality father-daughter time. I have a daughter, so I know EXACTLY where he was coming from. This is version 5 of a bridge I built for my Intro to Engineering class. So please take the hints and advice I'm giving you, build a few different versions and run a simulation. If you don't have SolidWorks or the simulation addon and you have a .edu email address...Autodesk offers all of their software to students for free. Autodesk Inventor can open some things from SolidWorks, but if you have any problems let me know and I'll see what I can do. Because of a 1/16" mistake when I built it, I had to break two of the diagonal sticks on one side to fit the weight plate. This of course was the failure point. However, from the first crack until a stick actually broke under the weight of testing, there was a very substantial about of time compared to the other 8 bridges. And no other stick even budged. Even with my mistake, we came in 3rd for total weight held and 4th in the weight/strength ratio. The reason why one horizontal stick appears to be higher than the one next to it, is because I taped 1/2 of the horizontal sticks together and carefully used my table saw to make dado cuts, to give my bridge some mechanical adhesion. I did this because in most of the videos I watched on YouTube, the bridges started to lean before they broke. I found the best way to assemble the bottom half was to put packing tape over a 2"x4" and spray it with just a touch of 3M adhesive. If you're patient and do it right, you will not have to sand and of the adhesive off the bridge. And forget getting anything on the bottom half set properly without some tweezers! Buying a balsa wood saw and miter block from Hobby Lobby was well worth the few dollars I spent! I also had some scrap 1"x4" that I cut to make a 2"x1" sanding block that had both a 45 and 90-degree angle an emery board (nail file) on each side to another piece of wood. If you only use an emery board, you will distort the perfect angle that you cut in the miter block. I also cut a 90-degree wedge in the ends of the diagonal sticks to offer some mechanical adhesion as well. If you're going to bend an arch, let the wood soak fo...
- 格式
- SOLIDWORKS、STL、Rendering
- 分类
- Construction
- 标签
- wood、bridge、balsa
- 数据更新
- 2026-11-11T19:09:56Z