Card Holder 模型预览

GrabCAD 模型信息

Card Holder · 模型 357477

作者:Chandler Rivinius

A card holder for standard sized cards that is quite frankly kind of a pain in the butt to make. You're probably better off just buying one from the internet because it will cause you far less stress and probably cost less, too. But should you be crazy enough to attempt to make it, you'll need to get the metal shells laser cut from somewhere. The inner plates are 3D printed, so that's easily enough, at least if you have an X1C. The nuts are M2x0.4 mm, which I found on Amazon, but used models from McMaster. The screws are M2-0.4 x 4mm which also came from Amazon but were also models taken from McMaster. Lastly, the straps are elastic band that measures 0.6" and require a bit of sewing to make work. So there you go. Have fun. Just buy a wallet. You've been warned.

格式
STEP / IGES、Rendering
分类
3D printing、Miscellaneous、Tools
标签
未标注
数据更新
2026-10-23T00:41:28Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。