GrabCAD 模型信息
Clutch Gear Holder 1983 Honda Shadow 750 · 模型 286286
I needed to remove the clutch gear from my 1983 Honda Shadow. Rather than buy the tool, I made this model to fit in between the posts that hold the timing coils and the clutch gear drive. In the service manual this is in section 7-23 on page 112. I recommend removing both pulse generators and printing two of these. I tried with one and it exploded when I tried removing the bolt. It's torqued to 80-100Nm (58-72 ft-lb). So I printed two and used 60% infill and it work great. The fit might be a little tight. I just used a hammer and tapped them in.
- 格式
- STL、Rendering、STEP / IGES
- 分类
- 3D printing、Automotive、Fixtures
- 标签
- 未标注
- 数据更新
- 2026-09-22T11:39:22Z