"Concept Car Chassis Frame Design and ANSYS Analysis" 模型预览

GrabCAD 模型信息

"Concept Car Chassis Frame Design and ANSYS Analysis" · 模型 364284

作者:Shekhar Mishra

This concept car chassis frame is designed in SolidWorks and exported as an IGS file. The model has a maximum length of 200mm and is assigned a circular pipe cross-section of 1mm outer diameter and 0.5mm thickness. ANSYS is used to analyze the model under the worst condition of a frontal impact of a static structural scenario, where the four corners of the front are fixed in place and a force of 100N is applied. The maximum deformation observed is 5.1714mm and the maximum stress is 9.891MPa. While this design is acceptable for a chassis frame under 200mm, larger frames would require increased material thickness to maintain safety standards. As an example, the Toyota Innova has a length of 4585mm, width of 1760mm, and height of 1760mm.

格式
SOLIDWORKS、STEP / IGES、Rendering、Other
分类
Automotive、Components、Industrial design
标签
shekhar、virus1260、shekhar mishra、grabcad、car chassis、ansys、solidworks、circular pipe section、structural analysis、deformation、stress values、worst case scenario、frontal imp、impact
数据更新
2026-10-26T14:58:09Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。