корона (Crown NISSAN ALMERA) 模型预览

GrabCAD 模型信息

корона (Crown NISSAN ALMERA) · 模型 393499

作者:Konstantin Net

Друг попросил для ручки переключения скоростей деталь на NISSAN ALMERA изготовить там куча нюансов 1-как снять правильные размеры с детали которая пружинит 2-внутри не отверстие а сфера 3-нарисовать проект 4- напечатать без поддержек при этом что бы деталь не сорвалась со стола на котором печатается почти до самого верха печатались очень тоненькие 8 столбиков толщиной в основании от 2 до 5мм после печати оторвать от стола так что бы не сломать модель) A friend asked for a NISSAN ALMERA part for the gearshift knob to make there are a lot of nuances 1-how to remove the correct dimensions from a part that is springy 2-inside is not a hole but a sphere 3-draw a project 4- print without supports, so that the part does not fall off the table on which it is printed very thin 8 columns with a thickness of 2 to 5 mm at the base were printed almost to the very top after printing, tear it off the table so as not to break the model)

格式
STL、SOLIDWORKS
分类
3D printing、Machine design、Tech
标签
crown
数据更新
2026-11-19T00:59:44Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。