GrabCAD 模型信息
Esp32 breakout board case and model · 模型 171741
This is a basic mounting case for the esp32 breakout boards you would find on the jungle site. This includes a measured model of the board with the esp32 attached. It is a friction fit without any actual latching but stays on pretty good for what I used it for. The board is held in place by 4 m3x6mm screws. These thread in but don't have it pressed against the table when screwing them in so as not to trap the plastic that gets pushed out.. it will snap off the riser. Case bottom version 2 has some side mounting tabs and wider risers with some minor relief for the thread debris
- 格式
- Rendering、Fusion 360
- 分类
- 3D printing、Hobby、Tech
- 标签
- small、basic、fusion、esp32
- 数据更新
- 2026-10-10T20:01:03Z
