GrabCAD 模型信息
Explosion Proof Fluorescent Lights - Paint Booths, Rigs - 4', 8 Lamp Fixture - Bi-Axial Bulb Design · 模型 197117
https://www.larsonelectronics.com/product/47186/explosion-proof-fluorescent-lights-paint-booths-rigs-4-8-lamp-fixture-bi-axial-bulb-design Made in the USA The Larson Electronics EPL-48-4L-BX Explosion Proof Eight Bi-Axial Bulb Fluorescent Light Fixture is NRTL Listed for United State and Canada Class 1 Division 1, Class 1 Division 2, carries a T6 temperature rating and ideal for hazardous locations where flammable chemical/petrochemical vapors exist or have the potential to exist. ***PLEASE NOTE: ANY FREE SHIPPING OFFERS DO NOT APPLY TO THIS HAZARDOUS LOCATION LIGHT FIXTURE*** The EPL-48-4L-BX fixture is a 4 foot long, 8 lamp, Class 1 Division 1 and Class 2 Division 1 & 2 explosion proof fluorescent light which is also approved for use in paint spray booth applications. This T6 temperature rated fixture comes standard with eight Bi-Axial 40 watt compact fluorescent bulbs which produce a combined 320 watts of illumination. The lamps are protected by heat and impact resistant Pyrex tubes and the fixture is constructed of copper free aluminum alloy. The lamp reflectors are corrosion resistant heavy gauge aluminum and coated with a high gloss reflective finish. The EPL-48-4L-BX provides operators in hazardous locations with an effective explosion proof lighting solution that provides more light than similar two bulb units. This Biaxial Lamp fixture is multi-voltage capable and can operate on voltages ranging through 100/120 Volts 60 HZ, 220 Volt 50 HZ, 240 Volt 60 HZ, and 277 Volts 60 HZ with 347 Volt and 480 Volt versions available upon request. Additional mounting options: Unless otherwise specified, our standard, most popular configuration is the bracket end mounting shown in the photos above. We also offer a pendant mount for those needing to suspend the fixture away from the ceiling surface (i.e. suspend from pipe or conduit). Standard Bracket Mounts: Each bracket is cinched to the bracket mounting peg on each side of the light. The angle of the bracket is set by tightening two cap screws on either side of the bracket. The cap screws act as a set screw. The bracket itself is mounted via a single bolt hole at the top the bracket. There are two brackets, one on each end of the light. Once the brackets are mounted to a surface (ceiling, floor or wall), the light fixture can be removed from the brackets by loosening the cap screws that hold the bracket to the mounting peg. The first picture shown above illustrates the ballast side bracket and also s...
- 格式
- STEP / IGES、Other、Rendering
- 分类
- Electrical、Fixtures、Industrial design
- 标签
- 未标注
- 数据更新
- 2026-09-29T01:33:06Z
