GrabCAD 模型信息
Foldable Laptop Stand · 模型 53686
FITS ONLY LAPTOPS WITH ONE CONTINUOUS RUBBER FOOT STRIP ALONG THE REAR EDGE. This stand seats against that strip. If your laptop has separate little feet at each corner instead, it will not sit correctly - please check before printing. See the photo with the red outline. Print-in-place folding laptop stand. Comes off the bed ready to use - no assembly, no screws, no glue. Fold it flat for your bag, pop it open on the desk. WHAT YOU GET - Unfolds from a flat 235 x 47.3 x 10 mm strip into a stepped riser - 15 degree typing angle - Every hinge has a built-in stop, so it locks open at a repeatable angle instead of flopping past it - Sized for 14 inch class laptops (roughly 220 mm front-to-back depth) - Folds completely flat again - one piece, nothing to lose in your bag - Bonus: folded up, it also works as a phone stand FIT CHECK - Your laptop's rear rubber foot strip must fall within the 235 mm span - 220 mm laptop depth gives the intended 15 degree tilt; deeper or shallower laptops sit at a different angle - Corner-only feet: not compatible PRINT SETTINGS Bambu Lab P1S, stock 0.2 mm Standard profile. - PLA - ABS or PETG will likely fuse the print-in-place hinges - 0.2 mm layers / 2 walls / 15% infill / no supports - Print flat as oriented, then work the hinges by hand a few times before the first full fold NEED A DIFFERENT SIZE? STEP file is included so you can adjust the span or the stand height in your own CAD tool. The print profile is in the attached Bambu Studio project file. LICENSE: CC BY-NC
- 格式
- STEP / IGES、Rendering、3D Manufacturing Format、STL
- 分类
- 3D printing、Computer、Household
- 标签
- travel、desk accessory、foldable、print in place、laptop stand
- 数据更新
- 2026-10-10T14:05:12Z
