GrabCAD 模型信息
FPV Armor Collection 1 · 模型 162876
1. Battery cover that fits most 4s & 6s LiPo 1500 mah batteries to protect them from scrapes and tearing upon impact. Battery holder fits around front and bottom of battery when battery is mounted to quad, than strap is tightened as usual, wires of battery hang out of open end, if too much pressure on sides of battery, do not use. 2. Toggle switch protectors for Radiomaster TX12, may fit other radios but I dunno. To install these simply heat the flat bottom with a heat source until plastic is soft than push onto curvature of radio and hold until plastic re-hardens, remove apply adhesive of your choice and than reapply. (epoxy... not recommended? ;)) 3. Antenna guard for protecting antenna from breakage. I take requests. All SLDPRT are version 2020 STL's available for each to 3d print.
- 格式
- SOLIDWORKS、STL、Rendering
- 分类
- 3D printing、Robotics、Toys
- 标签
- gimbal、drone、fpv、assist、security、guard、protector、antenna、1x16、t16、t12、jumper、radiomaster、12、tx、tx12
- 数据更新
- 2026-09-10T12:49:19Z
