GrabCAD 模型信息
Harry Vader's fully armed and operational Elder Light Saber Wand · 模型 256729
This is an iteration of a previous design that is printed with hollow parts to allow the installation of electronics. There is a 9 volt battery, power switch, keyboard key switch (Cherry brand), dual red/blue LED, and an Arduino Pro Mini (5VDC) tucked inside. I posted a video on YouTube on how to safely operate the wand/saber without casting spells on yourself or lopping off your own arm. (see below) Update : added files for a roomier handle with a threaded pommel - a sturdier seal and more room for the electronic doohickeys. Attributions : Adriano Cazzarotto : RGB LED : https://grabcad.com/library/led-rgb-5mm-1 Pamir : Arduino Pro Mini : https://grabcad.com/library/arduino-pro-mini-1 Oliver Darvas : 9 Volt Battery : https://grabcad.com/library/9-volt-battery-2 Kevin Yu : Cherry Switch : https://grabcad.com/library/cherry-mx-switches-mx-1 Mini Switch resized from a McMaster Carr item. B.O.M. : Power switch : http://www.microcenter.com/product/465454/miniature-snap-in-nylon-illuminated-rocker---red-switch Arduino Pro Mini (5VDC logic) : http://www.microcenter.com/product/486546/arduino-pro-mini-board Dual LED : http://www.microcenter.com/product/390134/led---dual-color-5mm-super-fresh-red-super-blue-3-pack Cherry switch : https://www.amazon.com/gp/product/B077TK5DL9/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 Keycaps (not exact match) : https://www.amazon.com/gp/product/B077C287J2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1 9 Volt Battery Leads : http://www.microcenter.com/product/497120/9v-battery-clip Super-Duper Glue : https://www.amazon.com/Bob-Smith-Industries-BSI-157H-Insta-Set/dp/B0166FFCHS/ref=sr_1_1_sspa?s=industrial&ie=UTF8&qid=1535459641&sr=1-1-spons&keywords=bob+smith+industries&psc=1 You'll also need one 10K pull down resistor for the push button input on the Pro Mini, and two 1K resistors for the LEDs. Assembly and Programming : Started assembly by gluing in the dual LED into the 'silencer' part (prewired with 1K resistors in line with positive leads). Fed the wires through the barrel and glued the barrel to the silencer. Glued the Cherry switch into the trigger part (prewired) and then glued the barrel to the trigger assembly. The little power switch in the handle just snaps in (prewired) and the handle is then glued to the trigger. All the electronics are then wired together and stuffed into the handle (after programming the arduino). The pommel is a snap in fit to finish. Update : added a new version of the handle and...
- 格式
- STL、STEP / IGES、Rendering、Other
- 分类
- 3D printing、Hobby、Toys
- 标签
- saber、light、wand、elder、vader、darth、wars、star、potter、harry
- 数据更新
- 2026-09-30T14:54:52Z