Microchip Snap In Programmer / Debugger Case 模型预览

GrabCAD 模型信息

Microchip Snap In Programmer / Debugger Case · 模型 334102

作者:Jorge Lino

This case is a remix of MPLAB SNAP CASE by sparky_summer on Thingiverse: https://www.thingiverse.com/thing:4848313 The main reasons for this remixed model: 1. thicker vertical walls and thus less likely to break 2.polarized connector (plug) to avoid inversion 3.switch to change operation mode, PIC/AVR (Some Snap In models do not have this 3-pin jumper on board). Switch: https://pt.mouser.com/ProductDetail/CK/JS202011SCQN?qs=LgMIjt8LuD95JYWxZ7NvZA%3D%3D The parts were printed on an FDM printer in PLA and with a 0.3mm layer without supports, except the cover that was printed with the external face up (in my case because i wanted this face perfect) Finish: water sandpaper (400, 600, 800) to get sides perfect, finally, several coats of cellulose varnish were applied at a distance of 30 to 40 cm to obtain a slightly rough appearance.

格式
STEP / IGES、Rendering
分类
3D printing、Computer、Electrical
标签
microchip、pic programmer、pic debugger、snap in programmer、snap in debugger
数据更新
2026-10-13T11:36:08Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。