GrabCAD 模型信息
Motion Sensor Prank PCB · 模型 242536
The motion detector / tilt sensor is constructed by integrating several techniques with each other. Including PCB layout, 3D printing, soldering, a bearing ball and gravity as the force for the motion detection. After motion / tilt detection a buzzer is activated. The rest of the time, the controller will go to sleep to save battery power. Only a wake up occurs when the value at the sensor pin change from the state it was before going to sleep. The prank motion detector has two operating modes after a motion detection, selectieve by two soldering jumpers: - Alarm mode, generating noise for minimal a minute after the last motion detection; - Prank annoying mode. Buzzer does not stop until power is switch off. How to make it, see link: https://www.instructables.com/Motion-Sensor-Prank-PCB/
- 格式
- Rendering、STEP / IGES
- 分类
- Electrical、Just for fun、Miscellaneous
- 标签
- electronics、elektronika、assembly、board、circuit、printed、pcba、pcb
- 数据更新
- 2026-09-21T01:43:54Z
