Multi part mold 模型预览

GrabCAD 模型信息

Multi part mold · 模型 418716

作者:Chris McCreary

A multi part mold for potting a circuit card in Soma Foma. Design challenges included precise and repeatable placement of a circuit card within a mold. Due to tight tolerances, thin parts of the molded product were prone to tearing, especially with a 2 part mold. A multi part mold reduced surface contact area, allowing easier removal. Leverages two 3D printer techniques - carbon fiber reinforced FDM for higher strength and lower porosity SLS for smoother surface finish. Design centered around interlocking parts that tightened from the downward pressure of the quick release locking hardware. Emphasis was placed on ease of pouring to meet the foam's 90 second working time. Weep holes were moved to easier to trim locations after removal. Precise location of the card was achieved by using cheap T-pins (https://a.co/d/7Bo3kSZ), which were trimmed to length using the trimming jig. *** Certain aspects of the molded geometry were modified to obfuscate end usage and respect IP. ***

格式
STL、Rendering
分类
3D printing
标签
foam、mold
数据更新
2026-11-12T14:14:44Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。