GrabCAD 模型信息
My flying bike · 模型 240339
lol ok the bike is based off a reversed trike but instead of tires it has props new build for the main motor just need to finish transmission 110/220 output main is setup just need 110/220 relay switch for arduino and main manual power switch note system will not power on if main on/off is in off this is to pre-amp device's before main system boots power lights in the manual switch will light when current flows in the on state now the main startup flip blue red green now flip main on/off switch the rpi should boot as soon as main lights up system boots check's all dev states once all states pass system config decides run-time five rts total (rt_1 rt_2 and so on) rt-1 is system check rt-2 is system rt state logs rt-3 is engine start rt-4 is generator meter rt-5 is system error
- 格式
- SOLIDWORKS、SOLIDWORKS、Rendering、Other
- 分类
- 3D printing、Aviation、Robotics
- 标签
- aviation
- 数据更新
- 2026-09-10T12:18:44Z