GrabCAD 模型信息
NASA Rassor Drum MK1 2.0 · 模型 267854
This Rassor Drum is almost the same as my previous version, NASA Rassor Drum MK1 except for the bolt holes and aluminum holding the outer aluminum frame together. This Rassor Drum has at least three support materials, except for the middle cylinder that has six, three on each sides that are lined up so they can be fused or bolted together in the files, there is a study that shows what stresses the axle will have. I also have a simulation of the Rassor Drum, "that is in backward because my computer can't run it in fowards :)" How it's built: the two outer aluminum rings are cut out along with the metal plates with the bolt holes in it. then they are welded together. after that is done, you make the carbon fiber, and bolt or rivet the two pieces together. finally, you just press fit the rings in the center of all the cylinders. "to prevent wear on the carbon fiber." requirements: 15.11'' by 11.23'' or 383.794mm by 285.242mm. It has a mass of 4.97. The scoops have a width of 80.01mm. Can hold up to 51 liters.
- 格式
- STL、STEP / IGES、Other、Rendering
- 分类
- Aerospace、Industrial design、Machine design
- 标签
- nasadrumchallenge
- 数据更新
- 2026-09-30T08:04:36Z