GrabCAD 模型信息

NIH DtM-v3 Face Shield for 0.8mm Nozzle · 模型 2764

作者：Aaron Neely

***EXPERIMENTAL*** I've tested this with a 0.010" / 0.25mm shield, but not with the thicker 0.02" / 0.5mm material called for in the original Prusa design. Primarily, I would like to confirm that the lower reinforcement snaps into place nicely on a 0.020" / 0.5mm shield. If anyone has a printer with a 0.8mm nozzle and can get their hands on a shield to test this for me, I would greatly appreciate your feedback! In the same way that I adapted the Prusa RC2/RC3 design for wide extrusion, I've adapted the NIH DtM-v3 to take advantage of the high flow rate of large-diameter nozzles (larger than 0.4mm) to increase production speed. With this design and a print speed of 50mm/s, I can print a headband in ~57 minutes. VARIANTS: 4 Post/3 Post: The 3 post variant is designed to use shields punched with a standard US 3-hole punch (4.25" between hole centers). The 4 post variant matches the original Prusa RC2/RC3 face shield mounting post layout and is cross-compatible with shields made to fit Prusa headbands. Stiff/Flex: The stiff models have consistent 2.88mm (3 perimeters) wall thickness. The flex models have 2.88mm wall thickness for the front strap and 1.92mm (2 perimeters) wall thickness everywhere else. I find the stiff models to be more comfortable because the arms of the headband better resist the tendency of the elastic strap to apply pressure to the sides of the wearer's head with the ends of the arms. Still, the flex models print faster and with less material, so I've included them. Brim: It is a common problem to have the arms of the headband lift off the print bed during printing, so I've added a small brim to each arm to help with bed adhesion on the "Brim" models. The brim can be trimmed off with flush cutters. I use Simplify3D for slicing, so the settings below are organized as they are in Simplify's profile system. These settings should translate to any slicer, though they may be named and/or organized differently. CRITICAL PRINT SETTINGS: Extruder: Nozzle Diameter: 0.8mm Extrusion Width: 0.96mm Layer: Primary Layer Height: 0.6mm Outline/Perimeter Shells: 3 Infill: Interior Fill Percentage: 0% ;(Infill disabled) External Fill Pattern: Concentric Support: Generate Support Material: disabled ;(Supports disabled) Advanced: External Thin Wall Type: Allow single extrusion walls Internal Thin Wall Type: Allow single extrusion fill I'm still fiddling with the remaining settings for PETG; I may come back and update this with an optional sett...

格式

Parasolid、STL、STEP / IGES、Solid Edge、Rendering

分类

3D printing、Medical

标签

dtm-v3、nih、rc2、rc3、covid-19、coronavirus、headband、shield、face、prusa、medical、3d、printing

数据更新

2026-07-11T16:29:20Z

前往 GrabCAD 查看