GrabCAD 模型信息
Oldie Vice · 模型 26604
For the most updated info check this out on my blog https://blog.ansonbiggs.com/oldie-vice/) Machinist Extraordinaire, [This Old Tony](https://www.youtube.com/channel/UC5NO8MgTQKHAWXp6z8Xl7yQ) recently put out a [video on a cool vice design](https://youtu.be/1mZhOlr5v-s) that I wanted to recreate. It is mechanically very simple and relies on a long rod with right-hand threads (clockwise) on one side and left-hand threads (counter-clockwise) on the other side. So, when the shaft is spun it causes the clamps to advance in opposite directions and at the same rate. This mechanism means that your workpiece is always dead center in the vice, and no matter the position of the clamps the vice takes up the same amount of area. [](https://www.youtube.com/watch?v=1mZhOlr5v-s) This model was made entirely in [Fusion 360](https://blog.ansonbiggs.com/tag/fusion360/) using the [This Old Tony Video](https://youtu.be/1mZhOlr5v-s) as a reference. If you watch the video, This Old Tony does a great job explaining how the Vice works and showing off the unique mechanism that allows the Vice to function. My model is not a replica, and is designed from the ground up to be 3D Printed.  ### Some Assembly Required This model comes in six different .stl files. The most challenging part about this model is the thread.stl which I go into detail about more later in the documentation. Assembly is very simple and requires no glue or anything that's not 3D printed unless you choose to use glue on some of the parts for better functionality which I would recommend. Below I have the assembly instructions embedded as a .pdf, but If that doesn't load for whatever reason, here is the rundown.  1. Thread on both clamps and Thread each clamp all the way down the thread going in a back and forth motion on any areas that give resistance to make sure it threads smoothly once fully assembled. Try to make sure they are both the same distance from the middle to ensure your clamped workpiece is always centered. 2. Attach both of the thread ends, the ends can become loose very easily, so its recommended to apply a little glue to make sure it stays but is not necessary. If you glue, it can become impossible to get off later without damaging the thread. 3...
- 格式
- STL、Fusion 360、Other、Rendering
- 分类
- 3D printing、Electrical、Tools
- 标签
- mechanical_device、bench_vice、electronics、pcb、vise、vice、string、screw、pcb_vice、jaws、fully_printable、design、household、thread、clamp、useful、tool、moving_parts、3dprinted、3dprintable、thisoldtony
- 数据更新
- 2026-07-11T00:55:19Z
