GrabCAD 模型信息
OpenMV Cam H7 and H7 Plus FLIR® BOSON® LCD Case · 模型 185693
This is the official 3D LCD printable case for your OpenMV Cam with the FLIR® BOSON®! The case perfectly fits around your OpenMV Cam while exposing all the ports and features light pipes for the board LEDs. We have a case cover that exposes the GPIO ports and one that does not. The case even features a battery compartment where you can fit a small 400mA lipo Battery from SparkFun (https://www.sparkfun.com/products/13851) under the camera. You can then power your OpenMV Cam from the battery, and the case comes with a cover to put over the exposed wire. No extra mounting hardware is required to use the case. You just need to make sure the pin headers are soldered on your OpenMV Cam. The lid snaps on, and we have a go-pro adapter. Finally, you can secure your OpenMV Cam in the case more tightly you use M2.5 nuts with M2.5 6mm screws to attach the camera to the case. However, these are not necessarily required thanks to the smart case design.
- 格式
- STL、Rendering
- 分类
- Robotics
- 标签
- 未标注
- 数据更新
- 2026-10-23T17:23:04Z
