Oxygen Flow Rate Splitter 模型预览

GrabCAD 模型信息

Oxygen Flow Rate Splitter · 模型 295430

作者:Terry

Pretty sure this one fills the brief. It uses existing Nasal Cannulas. The cannula connection end is threaded through the square slide and then pushed onto the barb at the top of the Oxygen Flow Splitter. This is done for both sides. The slide is then forced past the closed position on the carriages. The Flow Splitter can then be fitted to the Oxygen Regulator. The slides will squeeze the cannula to restrict the flow and can be regulated to flow rates via the embossed numbers along the slide carriages. The small grooves on the slide and the back of the carriage plus the expansion pressure of the tubing will keep the slides in position. Set the Oxygen regulator to the sum of the desired flow rate of both patient requirements and then set the splitter slides to suit, e.g. one patient requires 4 l/m and the other requires 3 l/m, set the Oxygen regulator to 7 l/m and the slides to 3 & 4 l/m respectively. The range of flow is from full open to full closed in 1 litre/minute increments. The hooks on the side can be used as storage for the cannulas when not being used. No chance of oxygen leakage as there are no breaks in the line from regulator to patient. Footprint is 137 mm x 140 mm x 33 mm. Can be easily 3D printed and main carriage body is hollow to reduce print time, weight and material expense. Total weight of assembly without the cannulas is approximately 60 grams (2 oz)

格式
STEP / IGES、STL、Rendering
分类
3D printing、Industrial design、Medical
标签
oxygenvalvesplitter
数据更新
2026-09-17T14:27:44Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。