GrabCAD 模型信息
Printable 1:13 Distributor Valve · 模型 115775
I made a 1-to-13 distributor valve to water my home greenwall. Most parts are 3D printable. Additional hardware required: - 1 NEMA17 dual-shaft stepper motor - 1 limit switch - 1 608ZZ ball bearing - ~2cm^2 of 1mm-thick PTFE sheet - 4 M5x20mm capscrews - 4 M3x10 screws - 1 12+" ziptie - superglue Update: I made this system about six months ago. It worked fine for a few months, but after a while it started to seize and wouldn't rotate between outlet positions properly. That's because I used partially-shielded ball bearings and eventually they rusted. If you use this system, which honestly I don't recommend, you'll need to use fully sealed ball bearings. I ended up replacing this distributor valve with a bunch of cheap solenoid valves.
- 格式
- STL、SOLIDWORKS
- 分类
- 3D printing、Agriculture、Interior design
- 标签
- 未标注
- 数据更新
- 2026-09-10T12:07:15Z
