GrabCAD 模型信息
RASSOR Convergence Collector · 模型 352031
Material: Aluminium sheet, Tunsten carbide cutters Total Mass: +- 4.7kg (excl. fasteners) Total drum volume: >44 litres Minimum volume regolith captured: >28 litres (one scoop cavity empty, material angle of repose = 0 degrees) Intended volume of regolith captured: 28 to 35 litres Minimum fill ratio: >63% Maximum particle size: 50mm diameter Scoop depth: 25mm Estimated filling time: +-2 minutes (30 litres) The collector consists of three sections. A central drum between two scoop sections. Rotation of the collector diverts regolith(via deflectors) in front of/under the drum towards the scoops located at the ends, where it is scooped up. Once inside the vessel, regolith is diverted internally towards the centre of the drum(via internal deflector plates). During the transportation phase, the bulk of the regolith is kept inside the drum by two main baffles and the internal deflector plates. When the direction of rotation is reversed, regolith is diverted outwards via the deflector plates and scoops. The design uses aluminium sheet, bent and fastened with rivets and/or machine screws. Drive rods are included to increase stiffness. Drive rods/hub dimensions are to be adjusted to fit existing RASSOR drive flange. Notes: Other materials should be considered as well as an anti abrasive coating. An additional baffle can be placed in each scoop cavity to minimize losses. Deflector angles(now at 30 degrees) can be adjusted to complement regolith properties, i.e. internal friction angle/angle of repose. Special care was taken to avoid elongated channels, as clogging of the collector whilst unassisted on the moon would be catastrophic. Although capturing ability could theoretically be improved by using parallel spirals as seen in many other designs, this approach is unrealistic for mining applications.
- 格式
- STL、Rendering、STEP / IGES
- 分类
- Machine design、Miscellaneous、Robotics
- 标签
- nasadrumchallenge
- 数据更新
- 2026-10-28T16:45:00Z