GrabCAD 模型信息
rc_car · 模型 72522
Theoretically could go up to 30 kmph assuming no losses, designed to run on 3s battery, a 1300 kv rated eco max 2 motor (spec sheet in the last) and 65 mm suspension. No holes for mounting anything as that could vary for everyone depending on what parts they're using, gearbox ratio : 9.8:1 , module is 0.8 for initial 2 gears and 0.9 for the rest, recommended to use heat inserts in the ball joints in the front control arm and and put a screw through the insert into the knuckle. For the rear control arms , use a pin sort of mechanism to attach it to the rear knuckle. for the rear shaft put some sort of thick screw/bolt/pin through the joint between the cv axle shaft and the central shaft, and put the pin through the axle shaft. l'll upload the steering model later. Also use a belt drive between the gearbox and rear axle shaft
- 格式
- STEP / IGES、STL、Rendering
- 分类
- 3D printing、Automotive、Robotics
- 标签
- 未标注
- 数据更新
- 2026-09-23T22:37:21Z
