teapot warmer (outdoor/indoor) 模型预览

GrabCAD 模型信息

teapot warmer (outdoor/indoor) · 模型 345171

作者:Thomas von Loh

I love drinking tee, but when I sit outside the candle was always blown out by the wind. Therefore I constructed this outdoor/indoor tee-warmer. A special highlight is a holder for the lighter. If you like to print this tee-warmer you should follow the Slicing-settings. • use ABS (PLA will melt during use) • set Perimeters to 0 • use Gyroid infill (ca. 8%, it is depending on the extrusion width) • I recommend Top solid layer of 3-4; a Bottom solid layer of min. 4 • consider that most settings depending on the printer you use

格式
STEP / IGES、Rendering
分类
3D printing、Hobby、Household
标签
tee、warmer、ikea、rikling、candle
数据更新
2026-09-21T13:05:49Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。