Thing ico Resin vapor aspirator for Anycubic Photon 模型预览

GrabCAD 模型信息

Thing ico Resin vapor aspirator for Anycubic Photon · 模型 384834

作者:Sergio Lanna

This accessory, to be installed in place of the upper glass of the Anycubic photon printer, will suck in part of the odor emitted by the resin during printing and, if properly connected with a rubber tube, will discharge it to the outside, for example by letting the tube come out through a window opening (I made the 15mm tube of external section pass through the shutter box so I can send it outside even with the window closed). All the elements to have the complete accessory can be found on: https://www.redpah.com/profile/16098/sergio-lanna In addition to the two printed pieces, you need a fan (recovered from an old PC, choose a fairly powerful and non-noisy one), 4 M4 35 mm bolts, 4 washers and 4 M4 nuts INSTRUCTIONS Insert the fan into the molded base by passing the power cable through the hole provided Apply the upper printed piece and fix it with bolts Remove the top cover of the anycubic photon by removing the 6 screws Insert the aspirator in place of the cover of the Anycubic Photon, fix it with the 6 original screws previously removed (if necessary use washers) Close the lid and insert a 15 mm tube of external section (sold in a common hardware store) inside the hole at the apex of the aspirator Now put the other end of the tube on the outside. You can pass it through a window or else, with a little more work, you can do as I did, by passing the tube along the edge of the window to the shutter box and from there outside, so I guaranteed the connection to the outside as well with the window closed To complete the work, the fan must be powered. To do this there are two possibilities: 1) get an adequate external power supply (normally the fan is 12 Vdc) 2) use the same power supply as the Anycubic Photon In the second case you will have to make a branch so that you can connect both the printer and the fan to the power supply And that's it! If you want you can add a wire switch to turn the fan on and off independently and without having to disconnect the plug every time ITALIANO Questo accessorio, da installare al posto del vetro superiore della stampante Anycubic photon, aspirerà parte dell'odore emanato dalla resina in fase di stampa e, se opportunamente collegato con un tubo di gomma, lo scaricherà all'esterno, ad esempio facendo uscire il tubo da uno spiraglio della finestra (io ho fatto passare il tubo, da 15mm di sezione esterna, attraverso il cassonetto della serranda così posso mandarlo all'esterno anche con la finestra chiu...

格式
Rendering、STL
分类
3D printing、Components、Fixtures
标签
3d_printer、anycubic、anycubic_photon、aspirator、part、particle、particle_photon、photon、resin、resina、stampa、3d、vapor、accessori、accessories、lanna、sergio、lanna_sergio
数据更新
2026-09-10T11:54:50Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。