Wood-fired Pool Heater – Pool-Specific Heating Stove 模型预览

GrabCAD 模型信息

Wood-fired Pool Heater – Pool-Specific Heating Stove · 模型 400281

作者:wt294

This wood-fired pool heater is engineered to keep outdoor pools at 30–35 °C using wood, cow dung, coal or charcoal; its secondary-air design slashes chimney smoke. The circulation pump can be built-in or supplied separately—mounted vertically or horizontally—to suit the site. Ideal for areas rich in wood or livestock waste, the unit heats a typical 8 m × 4 m × 1.8 m pool from 9 °C to 35 °C in about one hour (15 °C ambient, 2–3 m/s wind). Once 35 °C is reached, the controller automatically lowers pump speed to hold the set-point; if the water drops below 30 °C, flow increases to restore the range. A single wood load burns for roughly four hours: one hour for pre-heat and initial warm-up, three hours of steady swimming temperature—no refuelling required.

格式
STEP / IGES、Rendering
分类
Energy and Power、Industrial design、Machine design
标签
未标注
数据更新
2026-11-09T00:03:38Z
前往 GrabCAD 查看

CADSEEK 是第三方中文模型检索工具,与 GrabCAD 无隶属或官方合作关系。模型文件、许可与最终详情以 GrabCAD 原始页面为准。