GrabCAD 模型信息
X1C Plastic Ejection Chute · 模型 300304
I could have simply obtained one of these from the internet, but I had some unique space constraints and a specific size of 10 mm magnets on hand, so I devised this solution. It takes four 10 mm x 2.5 mm magnets. The magent holes are set to a nominal size of 10.15 mm. I think a person could get by with just a press fit ,but I opted to use super glue as a redundancy. It seems to work well enough as far as I can tell, but if you should decide to make this yourself, make sure you don't cheap out on magnets. The ones that I'm using barely have enough pull to hold.
- 格式
- Rendering、STEP / IGES
- 分类
- 3D printing、Hobby、Miscellaneous
- 标签
- 未标注
- 数据更新
- 2026-09-30T02:10:03Z
